F&G TECHNOLOGIES
Inspection of aerial, underground or underwater pipelines
F&G Technologies is proud to present the incorporation of the latest technology available in the world market, for the remote scanning service of Line Pipes

GWT (Long Range Guided Waves) Teletest Focus
- Teletest + is the world's leading system for the application of the Long Range Guided Wave technique.
- The system allows detecting corrosion in buried or aerial pipelines from a single point of application
- The ring is placed in a selected location on the Duct and Ultrasound Waves are fired through the duct wall, reaching a typical distance of 30m to each side of the ring.
- It offers a complete 360º scan from the point of application, allowing to identify where on the circumference the defect is located thanks to its ability to focus the waves on a certain point.

BENEFITS
- Ability to inspect Inaccessible Areas
- Only Local Access to the surface is required.
- Quick mapping for in-service diagnosis.
- Avoid removing and re-installing insulation and / or cladding
- Results at the moment and 100% coverage.
- Internal and external thickness loss detection.


SRUT (Short Range Ultrasonic Technique)
- Inspection under pipe supports
- Pipe interfaces
- Inspection of isolated lines with limited access. Corrosion detection under supports without the need for lifting.
- The data is completely recorded.
- Fully automated data collection protocols.



R-Scan manual ultrasonic system
- Lightweight corrosion mapping and fault detection system in Pipes, API Tanks and Vessels with a diameter greater than 6 inches.
- It offers a Scan B, providing an image of easy interpretation with the wear profile of the wall of the analyzed equipment.
- Through its built-in encoder, it offers a correct location of all defects for later traceability.
- It has a dry coupling wheel that avoids the use of water and favors coupling, giving a perfect graph of the real state of the analyzed piece.
- Scan speed up to 200mm / sec. Quick Measurement service with optimal results.



Phasor Series Phased Array Ultrasonic Flaw Detectors
- The phased array technique allows to minimize the inspection time for the detection of parallel and perpendicular defects in the circumferential welds of pipes
- It is a compact solution that adapts easily to any type of pipe geometry, both in diameter and in wall thickness
- Provides a solution that does not require as many mechanical adjustments, greatly reducing calibration times and allowing accurate inspection of welds
- Allows electronic scanning without the need to move the probe
- Simultaneous inspection with multiple angles and groups using a single transducer
- Facilitates the inspection of materials with complex geometries
- Generates a fully auditable inspection record

